FZ 07 Owners Club banner

Fender Eliminator Connection Problem

1718 Views 2 Replies 2 Participants Last post by  John
I need so some advice.

I just set up the fender eliminator - I connected the blinkers and they are working fine. But I cannot get the rear plate light to work nor the break light.

The two wires coming from the bike is a black and blue and from the plate light is a red and black. I tried all ways to connect these wires but the rear lights will not work. I tested the plate light and i know it works. Any suggests on what I am doing wrong?
For the blinkers i connected black to black and red (from the blinker wire) to white (from the bike).
1 - 3 of 3 Posts
Did your "eliminator" NOT have wiring instructions??? The Yoshi does. If you cannot find them, pm me and I'll find mine and tell ya the wire connections I have. With the Yoshi I just spliced the two tag-light wires and that was all that was needed. Certainly, nothing was done with the tail-light/brake-light wiring at all. The latter isn't a part of the stuff one removes.
Did your "eliminator" NOT have wiring instructions??? The Yoshi does. If you cannot find them, pm me and I'll find mine and tell ya the wire connections I have. With the Yoshi I just spliced the two tag-light wires and that was all that was needed. Certainly, nothing was done with the tail-light/brake-light wiring at all. The latter isn't a part of the stuff one removes.
yes - all done now and working great - thanks
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top