gs100a brake modulator

895 Views 2 Replies 2 Participants Last post by Gofast, Jun 25, 2020

Gofast

Discussion Starter · Jun 22, 2020

Ok, I tried to install the gs100a brake modulator on my 2018 mt07. I found the yellow wire is for the brake light. I spliced it into the red wires on the modulator but don't know where the remaining 2 black wires go.
Any ideas?

Save

1 - 3 of 3 Posts

MOTORCYCLEiD

· #2 · Jun 25, 2020

Hello.
Black wires are ground. Cramp them together and connect to the negative terminal of your battery. Make sure that the red wire marked "OUT" on the module goes to the light itself.

Save

Gofast

Discussion Starter · #3 · Jun 25, 2020

Thanks, I'll give that a try.

Save

1 - 3 of 3 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Home
Forums
Yamaha FZ-07 Forums
FZ-07 General Discussion