[wangshin248]

Hi guys, I just installed the HID projector light, so just wanna show you some tricks to do it, it's hard, but just pay attention then u will be fine !
-------

I bought two things from Amazon, and it's totally fit my bike
H1 Projector high and low beam : http://www.amazon.com/gp/product/B00B21R0TA/ref=oh_aui_detailpage_o02_s00?ie=UTF8&psc=1

HID light H1, DO NOT buy H4, : http://www.amazon.com/gp/product/B004ZF48D6/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1
You can find others, but hopefully it's not a crap

This tube ( MUST NEED ) or go to your local store, it should be there http://www.amazon.com/Permatex-8218...F8&qid=1427767905&sr=1-1&keywords=ultra+black

And your oven to bake your headlight or heat gun if you have one ( because you need to heat it to open the housing, but i do not recommend using heat gun )

----------------

Ok, now you have all you need, let's get it started

Step 1: open these screws, unplug all jacks inside it.

Step 2: bake your head light, put it in oven about 7 minutes at 205'F , not sure about that ? see this link

This is the hardest part, if you cannot open it, keep heat it, when it get hot, you should open it immediately, be careful ! I spent almost hour to open it, and try not to damage it !



Step 3: open the housing, and install the projector, make sure you put right side of the prjector

Step 4: apply "ultra black adhesive"

Step 5: put it back, and wire the ballast and light

Finally, my Cylop

 

[TDY]

Head light job looks good. How is the pattern on the road?

That may not be the best place for your parking sticker. It will make your fork seal leak when you hit big bumps on the road.

 

[ark207]

Any pictures of the finished product? Will other color bulbs work the same?

 

[ark207]

By finished product I mean how it looks at night