FZ 07 Owners Club banner

1 - 4 of 4 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1 (Edited)
Hey guys and ladies.... I bought these LED signals for the bike and proceeded to install them. After I finished taking the plastics and headlight assembly off I realized that it was going to take some work to get them mounted. I would like for them to be waterproof and look as clean as possible. My Question is how did you mount your indicators? Did you have to fabricate something or buy a special part? The top picture shows the tiny threaded stud that mounts the signal. Any help or advice is much appreciated.
20150825_211624.jpg
20150825_211416.jpg
 

·
Registered
Joined
·
74 Posts
Also....you can't work on a motorcycle barefoot. It's chapter six...paragraph three in the "Man Book".
 
  • Like
Reactions: bren
1 - 4 of 4 Posts
Top