[rdstryr]

Just a heads up everyone, both motodynamic and custom led now have integrated tail lights. Motodynamic has already released theirs and custom led looks like they'll be accepting pre-orders soon.

http://www.customled.com/products/2015-yamaha-fz07-integrated-led-tail-light

http://www.motodynamic.com

 

[Hypnotik]

My motodynamic light was ordered minutes after getting the email. It is already installed on my bike. I believe they are backordered again though.

 

[rdstryr]

My motodynamic light was ordered minutes after getting the email. It is already installed on my bike. I believe they are backordered again though.

Only the smoke lenses are backorder, white/clear is available.

 

[Sorkyah]

Ordered a clear, if needed I can swap it for a smoke when they're better available. I am wondering if their r6 flush mount signals for the front end will allow me to keep my running lights.

 

[rdstryr]

Thinking I might wait and pay a little more for the custom led version. They have a 2 year warranty.

 

[Magsz18]

Is the warranty the only thing swaying you or are there other reasons?

 

[rdstryr]

It has more modes when it comes to the brake alert, stealth housing rather than a smoked lens so you'll still get that nice look without compromising the light visibility, the sure blink feature, and that strobe mode is pretty neat. Motodynamic is keeping my interest with that Mustang like blinker feature though, where it flows outward in the direction your turning.

 

[USMCFieldMP]

Motodynamic uses resistors and from the person that I talked to, this is causing his wiring harness to get "very, very hot". Something to keep in mind. From reading their instructions though, it appears that it isn't too hard to disable the resistors.

CustomLED also sells the LED Turn Relay, as well as a Yamaha Turn Signal Pigtail. Ordered both for the LED turn signals that I ordered. The Pigtail is super nice since it makes it so that you don't have to chop up your existing wiring.

 

[doublethreat]

I have the Motodynamics integrated taillight/turn signal unit on my FZ09 and it's pretty easy to cut out the resistors completely and just install a plug and play electronic flasher unit for the correct flash rate. No over heating when that is done because the resistors are completely gone.

 

[NightFury]

This may be a dumb question but does anyone have an integrated tail light yet? I have not found one that is available. If you do have one did it come with a part to cover the hole under the tail when you remove the OEM fender/tag bracket? if so where did you get yours? I already took that large non sense off and relocated my license plate to the rear axle but I can't find an integrated tail light that is avaliable.

 

[Sorkyah]

This may be a dumb question but does anyone have an integrated tail light yet? I have not found one that is available. If you do have one did it come with a part to cover the hole under the tail when you remove the OEM fender/tag bracket? if so where did you get yours? I already took that large non sense off and relocated my license plate to the rear axle but I can't find an integrated tail light that is avaliable.

I bought mine from motodynamics, and used a yoshi fender elim kit.
No hole left, but in your case id recommend an ermax undertail kit, they dont look half bad, though the stock photo on their site is from the fz09
http://www.motomachines.com/Ermax-Undertail-for-Yamaha-FZ-07_p_5027.html

 

[NightFury]

I checked it out but I don't need the tag bracket, just looking for a cover plate.

 

[Mikey B]

http://www.ebay.com/itm/Smoke-For-Y...ide-/221744055183?hash=item33a0f9c38f&vxp=mtr

Anyone have any experience with this product? Was looking for an alternative integrated tail lights and found this on eBay.

 

[mike d]

http://www.ebay.com/itm/Smoke-For-Y...ide-/221744055183?hash=item33a0f9c38f&vxp=mtr

Anyone have any experience with this product? Was looking for an alternative integrated tail lights and found this on eBay.

That looks pretty cool! I too would be interested in hearing feedback on that.

 

[ciguli]

Smoke For YAMAHA FZ-07 2016 2015 14 13 LED Tail Light Turn Signal w/ Light-Guide

Anyone have any experience with this product? Was looking for an alternative integrated tail lights and found this on eBay.

Does anyone have this? Looks great, but I don't know its build quality.

 

[s0nicsvt04]

FYI: TST Industries has a plug and play integrated tail as well with different flash settings in clear and smoke.

 

[EmileNailk]

Ok. So seeing the fzr 600 the tail light has 2 bulbs on it is there any way you make it integrated. so that each one blinks seperatly when i turn the blinkers on. If not i think im just going to rig up some LEDs.