FZ 07 Owners Club banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hello fellow riders!!!
I need a bit of advice and I think you might help , I just got the T-Rex frame sliders and engine cases for my 1015 FZ07 but was wondering if I should use a torque wrench to screw the screws back in on the frame and case, I though just a normal socket wrench and some ''common sense'' will do but then again it might not, I've never used a Torque wrench and I'm not sure what are the specification to re screw the case , any ideas?
Thanks!!!!
Oso
Auto part
 

·
Registered
Joined
·
15 Posts
Torque wrench is a little overkill, if you got one... case cover bolts only need to be snug. If you have a feel for hand-tightening, then I wouldn't bother with the wrench.

You're going to need Allen/hex keys, sockets or bits for those bolts.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top